Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can there be multiple SSIDs pointing to the same vlan/mob grp? Also can one 'rename' a SSID that is already created or should it be wiped out and a new one recreated?I assume each SSID needs to be tied to a VLAN unless one is a guest SSID. Can one h...
We have a situation where we must back rev a WLSE from version 2.13 to 2.11 in order for us to convert APs from VxWorks to IOS. Unfortunately these APs were missed before the WLSE was upgraded.Anyone have comments relating to going back a couple of r...
Anyone know how to use the existing Cisco console cable for the model 1200 (9 pin female to RJ45) on the old model 350 with a female 9 pin serial port. I have tried 9 pin adapters with the Cisco console cable.To compound problems I have laptop with o...
We are running Vocera over a Cisco 1200 deployment using a separate VLAN and employing WLSM. Connections are fine and communications are fine but they are getting inconsistent broadcasting results. Folks never hear the message.dtim is set to 1Thanks,...
As crazy as it seems the title of this message is what we are seeing on a wireless network. That SSID is no where on this network and never has been. However, we are seeing it be used by numerous clients, which are carts with a small form factor PC b...
The solution to this problem was configuring the Cisco edge switches with the following command:no ip igmp snoopingThey were using version 3.0 Vocera and Cisco has this feature enabled by default. As soon as we turned off igmp snooping it resolved th...
The Cisco 1200 console cable is unusable on the model 350. The only cable usable is a straight through 9 pin serial cable with male on one end and female on the other. I had the USB to serial cable already and was hoping to use the console cable from...
We have come to find out this maybe imbedded on the chipset by Atheros. The crazy part is the only profile for these clients is one with obviously a different SSID.We have seen this on Airmagnet as well, and the clients contiuously use this in their ...
What we found is if the broadcaster is on APs which are connected to one switch and the recipients are on APs connected to another switch - it does not work.If, however, both broadcaster and recipients are on APs connected to the same switch - broadc...
