Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,When I installed new GLC-LH-SM to card WS-X6724-SFP on sw 6509, the switch disabled interface and gave an error message: "%PM_SCP-SP-3-TRANSCEIVER_BAD_EEPROM: Integrity check on transceiver in LAN port 1/20 failed: bad key".It also had the sam...
Hi all,I have one FWSM on router 7609. And will router bypass all traffic to FWSM when FWSM fail (I mean MSFC will process this traffic)?Thanks in advancedMinh Tu
Hi all,I am trying to deploy the MPLS L2VPN Service on router 7600 using Vlan interface by ISC4.1 but the ISC don't see Vlan interfaces.The router 7600 have sup720, don't have SIP-600 or OSM card.I read release note for ISC4.1, the ISC4.1 do not requ...
Hi all,I make some configuration mistake. It'w fixed and now all TE tunnel work with FRR.By the way, can anyone explain more about the limited support for TE on port-channel?Thanks anyway,
Hi,I configured TE and FRR on Port-Channel also. I saw some TE Tunnels worked with FRR, some didn't. I enclose here for reference.Router#sho mpls traffic-eng fast-reroute database Headend frr information:Protected tunnel In-label Out int...
I have SIP-200 on routers. In Provider/PE Devices, ISC sees SVIs but they're dash (no configurationable).This is the configuration by CLI:acc-76#sho mpls l2transport vc 501 deLocal interface: Vl500 up, line protocol up, Eth VLAN 500 up Destination a...
Thanks for your help. I just use EoMPLS not ATOM and I can configure on interface VLAN by CLI. The problem that ISC doesn't see interface VLAN.Do I miss any options on ISC?RegardsMinh Tu