Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Morning All,
I have a quick question. Concept of native vlan and dtp is clear. No need of link to both concept.
Target of the test -> Test the behaviour of Native Vlan. Create untagged traffic and check if it is carried over the native vlan.
Te...
Hi, I have a quick one. On the config guide of the nexus 7k you can read the following You can configure the router ID. By default, Cisco NX-OS sets the router ID to the IPv4 address of a loopback interface on the router. If no loopback interface is ...
Hi all,I have a problem and I really do not know the reason.Simple scenario. I need to configure ospf into a ASR1004 router.Here the command vrf definition TEST-02 ! address-family ipv4 exit-address-family!!interface Loopback25 description TEST-02vrf...
Hallo All, I would like to translate an extend access list in a prefix list. ip access-list extended x_to_ypermit ip 1.1.1.1 0.0.1.255 anydeny ip any host 3.3.3.3 Any hint? Thanks!!!
Hi All, Simple question. I have two switches connected via 1Gb link. They are running rapid pvstp. The layer 2 topology is the one below depicted.I now need to upgrade the connection with a 10Gb link, keeping the 1 Gb link for backup. My question is:...
Hi Jon,
Thanks.
SVI have been created as stated before.
L3 devices yes. Ping is working between R1 and R2.
Configuration should be also ok.
Wireshark is showing me the arp request leaving the R3 but no reply. It looks like that R3 has a different b...
Hi Richard,I agree, then I think I mixed up the answers and I mixed up with ospf concept as well.In briefI will shutdown the interface so of course I am exepecting the shutdown of the bgp neighboprshipThe BGP process will never reset in my specific ...
Hi, Thank you for the reply but it is not clear.You statedThe 7K should keep using the router-id it has been configured with, i.e. the interface xyz, because you have "pinned it". Again, what will happen when the interface xyz is down? Which router-i...
