Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi, i have ASA and there is site to site vpn configured with SITE-A. now additional requirement , i want to create one more tunnel using VTI (GRE) also , i have to translated two of my local subnets as there is IP address conflict on the other side S...
hi ..
i have L3 core switch with 5 no of vlan configured , with VTP mode server,
there 5 access switches connected to core with vtp client mode..
vlan 10 - 192.168.10.0/24 - management
vlan 20 - 192.168.20.0/24 - server
vlan 30 - 192.168.30.0/24 - da...
Dear All,Am using 867VAE-W-E-K9 router at home for ADSL purpose and WiFi. But the Wifi singnal is very very low and i don't use any other device with wifi enabled. Is there any way that i can improve the signal strength?? Kindly share your knowledge....
Dear All,
I have ASA 5525 in which two ADSL connected with fixed IP address. ASA inside interface connected to a layer 3 - 3750 switch in which four vlans are configured.
Plan:
Planning to route all internet traffic on one ADSL line and other one d...
Dear All,
I have ASA 5525 in which two ADSL connected with fixed IP address. ASA inside interface connected to a layer 3 - 3750 switch in which four vlans are configured.
Plan:
Planning to route all internet traffic on one ADSL line and other one d...
Hi Thanks for your support.
So how can i do nat translation , over VTI?? is there any way?
yes crytomap and VTI can co-exist, i have a simulated this one.
so only problem , i want to do nat translation over VTI interface
Dear Thanks for your support.
When i configure PPPoE , its taking IP address from ISP (either DHCP or static) along with gateway address. Still you want me to configure two static route along with different AD value. Can explain please? Thanks for yo...
