Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I'm attempting to re-install Ciscoworks onto our Solaris 5.8 server, and keep getting the same erros:Installation of <CSCOcvw1> was successful.Application CSCOcvw1 CiscoViewERROR: Package verification failed : CSCOcvw1 aborting.=========...
Hi,Customer has Cisco837 (Site A) and a PIX 501 (Site B). working perfectly in a site-to-site VPN. A remote access VPN is configured on (B), but because of the PIX routing limitations, they of course can't access site (A). Has anyone has any success ...
Hi,I've got a two site VPN using routers. The VPN itself is fine, BUT - at the Head Office end, the customer has static NAT entries to allow incoming connections - any service which has a static NAT to allow incoming connections from the Internet is ...
Hi,I'm running CW on a Solaris 8 box. I can access CW happily from any other PC on my network, but not from the server itself. I've finally managed to get both Netscape (4.76) and Java working correctly, so I'm a bit stumped. I no longer get a "java ...
Hi,Customer has removed a static NAT entry and replaced it with a new one - uses the same original destination but a new NAT'd destination. "clear xlate" removes the old entry from the xlate table, but as soon as anyone attempts to access the host, t...
Without more information about your DSL connection etc., I would say that you problem is caused by the Linksys attempting to run PAT on the IPSEC packets - IPSEC doesn't work in this type of configuration. You need to configure the "pass-through" opt...
That's what I thought I'd done, but the static translation seems to take precedence, even with the route-map in place. The router is running 12.2.(11)T2, btw.
