Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an Ethernet WAN connection to a remote site via a service provider at say 10Mb/s. I have 3 VRF's on the remote router so I need 3 Ethernet subinterfaces, one for each VRF. Can I have QoS and shape traffic in a way that allows any of the VRF su...
I have been installing Light Weight AP's and these make LMS device discovery take much longer because they are found via CDP but do not run SNMP. So you suffer the SNMP retry and wait time for each one which adds up with several hundred AP's. I added...
I have two 7206 routers that I can't get the configs from. I have double checked credentials. The failures show as:CM0151 PRIMARY RUNNING Config fetch failed for ber10 Cause: TELNET: Failed to establish TELNET connection to xxx.xxx.xxx.xxx - Cause: ...
If I replace a device with a different type but keep the name and IP address the same, will LMS and associated apps learn about this automatically? Or will I have to manually delete the old one? I have noticed a Cat4006 was replaced with a Cat4506 a...
Michel, I did add them to system-config.xml but this is not working. I am wondering if there is a limit to how many CDP platform ID's can be listed in system-config.xml. I am also wondering if the trailing spaces in the CDP platform ID of the LW AP's...
I read the post from Joe and I have had him help me before with similar issues on IP Phones. I tried the same thing for LW AP's and its not working. I was hoping someone would have run into this and know if this is a defect in LMS or if there is some...
OK, I figured out the problem. These 2 devices do not use TACACS but all our other devices do. These 2 use the password on the VTY lines and an enable password. In the device credentials I was specifying the VTY password as the USERNAME and then the ...
