Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Right now I have a lab setup with a couple of these AP's.They are both doing DHCP to get their IP address from a 5508.How do I set a static IP address on the AP? I cannot for the life ofme figure out how to do it.Thanks.
Recently had something come up with ICMP type 5 redirects and wondering if someonemight have an explanation as to why its happening.A small corner of our network has a 3560G connected to Juniper MX.There are various vlans on the 3560, which vlan 1 is...
Have 4 switches a mix of 3560 and 3550's in a test lab.test-sv1 and test-sv2 connected via dot1q. Vlan 2 is setup on each switch withtest-sv1 as 192.168.31.2 and test-sv2 as 192.168.31.3 and a standby 1 ip 192.168.31.1.test-sv3 and test-sv4 connected...
If I add a list of MAC addresses to a 2504 to the MAC filter first does it do anything until I actually turn onMAC Filtering in WLAN -> Edit - Security - Layer 2 - MAC Filtering?I'd like to add a list of MAC's to a remote site first then when I'm ons...
Thanks very much. We had a complete site survey done of where to place AP's, but one of thethings that did not seem to get covered was RAP to MAP ratio and its going to be quite a largearea that we plan on covering with wireless.Thanks.
I have been thinking from the CLI point of view on the AP. I should have clarified.When I see people mention to 'prime' an AP before it goes out what does thatmean exactly?It seems that when a new MAP is powered up it will associate with the RAP andW...
