Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Having trouble getting a 2621xm to register with Flowroute SIP provider.show sip-ua register status comes up with nothing:R2#sh sip-ua register statusLine peer expires(sec) registered============ ============= ============ ==...
I have a Cisco ASA 5510 with 3 inside interfaces each connected to a 3750X switch port in a vlan. Outside interface is connected to external router with 209.155.x.x public IP. Static route exists for outbound traffic on outside interface.3750X is con...
Jagpreet, thank you very much! This command got it working:ephone-dn1 number 12345As soon as I entered that, the debug messages started flowing and the router sucessfully registered with Flowroute:Router#sh sip-ua register statusLine peer ...
I'm seeing these messages in the debug:Router(config)#*Mar 2 03:43:42.301: //-1/xxxxxxxxxxxx/SIP/Info/ccsip_register_configured_dest_patterns: No destination patterns to Register*Mar 2 03:43:42.301: //-1/xxxxxxxxxxxx/SIP/Info/ccsip_register_reset_d...
debug ccsip all shows nothing. It's like the router isn't even trying to reach out to sip.flowroute.com.I waited a few minutes, but no messages in the terminal:Router#debug ccsip allThis may severely impact system performance. Continue? [confirm]All ...
Ok, I've bypassed the linksys and connected the 2621 directly to my cable modem. I can ping out to sip.flowroute.com and there are no inbound access rules.But the router is still not sending sip packets to flowroute. I engaged flowroute support and t...
Tarik,I changed our setup per Jouni's recommendations, and that fixed our internet access problem.But we still could not ping internet hosts from the inside interface. Adding the inspect icmp to our global_policy allowed the pings to go through.Thank...
