Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm a bit confused regarding the native Vlan of 1262 bridge ...My design is LAN---RAP ---- MAP---remote-SWITCH with two Vlan : one for the data and one for the management.I keep the vlan 1 for management at this point, but I'm still unable to acce...
Hi,I have one wcs (5.0.56.2) and two wlc 4400 ( 5.0.148.2). When i try to create a ticket for guest access on the two wlc without time restriction, it works well. But when I defined time restriction for the ticket, i have a snmp error on the passive ...
Hi,I want to upgrade my WLC for meshing network. The last release is 4.1.192.22M but in the release note it's write 4.1.192.17M in the upgrade path ...Another point is that the release 4.1.190.5 isn't present int the download section.What's the path ...
Hi All,I will installed two APs 1522 for mesh network on poles, is it necessary to buy the hand strap tool AIR-BAND-INST-TL and how many ? In the doc, there's a ref too for a Band Hand tool AIR-BAND-IT-TOOL, what's the difference ?Thks for your respo...
Thks Scott,I was working with that doc and If my understanding is correct so it's not possible to have the same management Vlan (ie address plan) on both side.Even if I use Vlan 2 for example, the RAP-MAP management adresses will be on the IP range o...
