I have run into a couple of instances where after a config change, CNA tells me a device is not supported and cannot be added to the community. This on a device that previously was a community member. Any ideas?
Can anyone help me understand the real differences between the "IP base" and "IP services" IOS's for the 3550, 3560, and 3750 series switches. Thanks for the help.
I tried using the original setup with no username, but still will not work. Do not use SSH.If you send me your e-mail, I can share the configs and screenshot.Thanks
http://www.cisco.com/en/US/docs/net_mgmt/cisco_network_assistant/version5_0/release/notes/OL12210a.html#wp699844Click on Devices Supported on this page to see your devices. Ver. 5.4 should work for you.Good luck!
Just think I should stay current with the new release. I am rebuilding this switch for a redeployment to a different part of the campus. It will be used more as a L2 switch within that subnet instead of the routing functions it previously did.