Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
where's my damn code? I've been failing over and reloading my firewalls at least daily for the last week. Workaround is to turn off CoA which is enabled to interact with ISE (btw, that's a Cisco product). This is bloody ridiculous!
This one bit me again. Not sure what I did to fix it two years ago, but here's the fix now.
From rommon-2> set BOOT=flash:cgr1000-universalk9-mz.SPA.156-3.M4 (or whatever IOS code you see in 'dir')
reboot
router boots IOS but does not retain environm...
I have used the CONFIG RESET to supposedly "return to factory defaults". Instead it is now a rommon-2 brick. tell it to boot the ios but returns to rommon after several minutes.
