Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know if it is possible to use wildcards with a Shell Command Authorization Set? I am setting up the following types of users:Cisco Admins (Unrestricted)Cisco Operators (restricted, but capable of a lot).What we want to allow the operator...
Cisco Works WILL nuke the bootflash & put only the new image on it...I have ALSO had problems with CW not recognising that the switch HAS rebooted. Therefore it fails the job.I currently have a TAC case open and a Developer looking at the debug file...
So... I this config you have two VLANS, but one SSID.You are using VLAN 100 as your "managment" VLAN, for wlccp & CDP, and management Access, but you are using VLAN 200 for the Wireless users.Is that correct? Because that is exactly what I want to ...
