Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to get a single tunnel up between an ASA, v9.12(2) and AWS. I have ike working but can't get IPsec to come up. Local tunnel end is 130.108.109 and remote is 3.244.244.33. I think I have the basic settings correct since ike is working:cr...
I have several stacks of 2960-X switches running various versions of IOS 15.2 code. I've been asked by our Telecom group to see if I can find out the power draw of the stacks in each data closet. I can pull some info via the "show power" command:
...
I'm migrating AnyConnect users form an old ASA 5520 to a new ASA 5516-X. For some reason my OSX users are now seeing the attached Web Security: Service unavailable message. Does anyone have an idea what would be generating this message? I'm not do...
I've searched CSC as best as I can so I appologize if this is a duplicate topic. I have an ASA5505 v8.4(1), ASDM version 6.4(1). According to the release notes you can setup two factor authentication in these later versions of ASA code. What I can...
I have an ASA5505 (ASA version 8.0(4) ASDM version 6.1(3)) that I have setup and working using LDAP for authentication. What I'm trying to find out is if I can set an account up that uses the local database for authentication. We had a situation th...
As a follow up it turns out I had the config correct. The problem was at the AWS end where the interesting traffic wasn't matching what I was told to use. Once they corrected that end the tunnel(s) came up.
Here you go Rob. Traffic generation might take me a bit since I don't have any access to the servers on my side I'm trying to link.mc-fpr-asa# show crypto ikev2 saIKEv2 SAs:Session-id:316, Status:UP-IDLE, IKE count:1, CHILD count:0Tunnel-id Local Re...
