We recently purchased a Cisco 877W for our office, this replaced the 2610 we had there for over 2 years.The 2610 has always worked flawlessly with any ADSL broadband provider. The 877W however has been shutting down and bringing up the ADSL port on a...

I am attempting to connect a single E1 channel to a Martis DXX using frame-relay. Till now, no success.I have setup a subinterface which has the state of "interface up, line protocol up".The subinterface has an address.The cisco is sending LMI reques...

We have 2x 7206VXR routers with multiple serial interfaces (E1's). I would like to upgrade to a later version IOS but since the current version 12.0(7)T does not support "Ifindex Persistence" I will have to reconfigure both MRTG and Intermapper. :(I ...

Before I go out and purchase a NM-T3/E3 for a 3725, I would like to find out whether there could be any compatibility issues concerning the connection to a 7206 PA-2E3 on the other end.At present we have 2 7206 routers connected via PA-2E3 modules, b...

HiI have found a number of OID's on the 5300 for information on the modems, but I fail to locate a suitable OID for the throughput values of each individual modem.In particular the usage per modem(s).Any pointers?Lutz.