Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all~I'm very curious.If my camera is failure, so I need to replace that failed camera, then what happen on the video in that camera. Is there any way to restore my video from that camera? or does meraki support center restore the video?Thanks & re...
Hi expertsI have some questions about ace's behavier.1st one is, Does ACE send a RST packet when it reach to inactivity timeout?2nd, Does half-closed timeout works properly with "no normalization"?3rd, How does ACE treat the packets there is no flows...
Hi thereI'm Kilsoo.I made One-armed mode using ACE.Real servers are in away Vlan from ACE.So, I configured the PBR with ACE alias ip address for the next-hop on the real server's gateway interface.And, the probe from active ACE works well.But, the pr...
I tried to apply QoS on C7507 FSIP.But the router displays a below message.shb_rt1(config)#int s5/1shb_rt1(config-if)#service-policy output NewBank_Policy service-policy is supported only on VIP interfaces with DCEF enabledI know dCEF can enable on V...
I know that "show cable-diag tdr int [slot/port]" command can check 10/100/1000 etherent link. For example WS-X6748-GE-TX... etc.But I can find any command to check gigabit only ethernet link. for example WS-X6724-SFPIs there no command to check fibe...
Thank you CesarIf you're not wrong ACE doesn't send a RST packet when it erase the conn list from conn table after idle timed out but it se nd a RST packet when client or server try to send a data over a connection that is already timed out.Thank yo...
Hi CesarI'm very appreciate of your reply and help.I want to correct my 1st qeustion.My 1st qeustion is Does ACE send a RST packet when it erase connection list from conn table after idle timeout?Thanks
Hi CesarThanks for your reply.But I think I was confuse when I wrote the message.I used both ace's vlan ip address for next-hop ip address like your advice.Do you know the standby ace can't check probe without route-map in one-armed mode like below d...
I found a below document in Cisco.comAs of Cisco IOS Software Releases 12.1(5)T, 12.1(5)E, and 12.0(14)S, only VIP-based or distributed per-VCqueuing is supported on the 7500 Series. RSP-based QoS is no longer supportedRSP-based QoS is no longer supp...
Thanks for your answer.I want to check a optical dBm at running switch. So I want to forecast a possiblity of optical link problem with low dBm.Is there any way I want?Thank you
