Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I recently installed an IP-PBX phone system behind a 887VA as per attached image but I now have two issues. Firstly I’m unable to manage the IP-PBX device either locally (LAN) or remotely (WAN). I can ping the IP-PBX device from within the ro...
Hi, I've created some port forwards from my public IP (Dialer0) to our private LAN but only the 25565 port forward works. I've even added an anyany statement to the Nat source list Homenet_NAT. Any help would be much appreciated, full config attached...
Hi all, Please help with an annoying ACL issue. I have the following extended ACL configured but for some I still can’t get web access when the time range is active.The email and other ports work perfectly but when the time range shows active in the ...
Hi all,I have two Cisco 888-K9 setup on a 4 wire private line about 2-3 km apart one configurated as CO and the other as a CPE. During config and testing the SHDSL connection was completely stable although this was only over about 300m of CAT5e. Now ...
Hi all,I'm having difficultly with the below ACL. No matter which interface (dailer or fa) I apply it to all IP traffic gets blocked. I must be missing something as I tried this ACL on 3 different 800 series routers all with the same results. Any hel...
Hi Alain,Ok here are my results. Firstly when I removed in zone from Vlan1 interface I lost internet on the PC I was connected too. Secondly removing the zones appears to have had not effect as I was still unable to connect remotely or locally to the...
Thanks Alian, all working and yes I had to add the local ports to ACL 103 for traffic to come through.I wish I had a full understanding of the policy maps and class types.CheersLouise
Thanks Alain, testing now. Just one question how come the 25565 port forward was working but 3389 would'nt work even if I changed the destination to 192.168.0.100?Louise
Hi Alain,Thanks for that, so what is the syntax to create the required entries in the class maps? Would that also be the reason why I can't use CCP to connect to the router as it always comes back with discovery failed?Louise
Hi The web traffic (http, 80 and https, 443) are allowed in lines 60 to 90 per subnet which inturn is controlled by the time range QQQ_Control, the Cisco IOS changes port 80 to www when you type it into the ACL.60 permit tcp 192.168.2.0 0.0.0.255 eq ...
