Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Very Likely, however, you may like to reseat in a different slot if you have an available empty in order to rule out any issue with the slot.
Also, visual inspection for any damage in the connectors and bent pins is recommended
Deepak,This error was reported by your PLIM ASIC (PLA0). We have 2 of them on every PLIM. This is a log level 5 - notification.That said, its better you proceed with a TAC case as you might want this to be looked just to be safe.If you like to track ...
Hi Steve,On a nut shell, your looking at all the blocked process in the PRP3 and obviously you can run this against every LC.Some of the processes meant to be blocked while other are not supposed to. Each process has its unique job id, process id and...
