Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, Im looking for a way to setup a separate tab in Finesse desktop with a list of pre-configured buttons that are basically blind conference. It will conference in other uccx applications that play re-recorded messages. Im able to setup the tab...
Hi All,Has anyone been able to make this work?I have it configured and working for SCCP by creating a blank translation pattern but when the same configuation is set for a 9951 it does not automatically dial to the translated number. This is in Call ...
Hi All,In cme can you designate a specific button for a speed dial like a dn.I have ephone 21 mac-address [mac] type 7961 addon 1 7914 button 1:21 2:29 3c1,2,3,4,5,6,7,8 speed-dial 1 88 label "Pager" speed-dial 2 XXXXXXXX label "XXXXXX" speed-dial ...
Hi guys,I have the classic disconnect problem and with all the terrible bytes on the internet have be unable to find the appropriate solution.If i ring the PSTN line connected to the FXO port i have PLAR directing the call to 1000 my Reception phone....
Long story short....I had to create a blank SIP dial rule simular to the blank translation pattern. Once selected on the phone it all worked fine.Call Routing > Dial Rules > SIP Dial Rules . AddThen Find the phone and under Protocol Specific Informat...
What fixed it....opx int the plar commandand freq-max-deviation 20cadence-variation 50int the voice class attached to the fxo port....voice class dualtone-detect-params 1 freq-max-deviation 20 cadence-variation 50!!voice class custom-cptone TEST dual...
hmmm okbut if "On an IP phone, speed-dial entries are assigned to unused line buttons: is true.... why is the speed dials not showing up on the unused buttons 4,5,6. It seems that speed dial must start after all button configurations. But that does n...
I was speaking with some ccvp's and ccie's and i have been told that loopstart has a known problem and if i get the telco company to change it to ground start, ill be fine.
12.4.15T hmm ok ill try that...i let you know how it goso far my conf looks like thisvoice class custom-cptone TEST dualtone disconnect frequency 400 cadence 380 380 380voice-port 1/1/0 supervisory disconnect dualtone mid-call supervisory custom-cpto...
