Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Some guidance / Help please!!!
I have a DNAC appliance running ver 2.2.3.5. It unexpectedly lost power, and when it was brought back online it went to a screen where the last message was "Press Enter for maintenance (or press Control-D to continu...
HI, I'm really hoping there's a simple solution!!! I have a pair of 8510 WLC's in HA. Running 8.5.161.0, I've just upgraded to 8.5.171.0 (current "golden Image') There are 1907 AP's joined most of the time. However, there are 2 issues being experienc...
Hi Leo,Thanks for the response.They are 2960X switches of varying port densities.For more clarity, the issue we found, was that after issuing an upgrade from DNAC/CCC to a group of ~60 2960X switches using the SWIM process in DNAC/ CCC. On the dashbo...
Hi,
Yes, the maglev console still had commands but i had no idea which to run - I tried booting into Linux recovery mode and that broke everything - I'm re-installing from a flash drive AGAIN. Clearly these UCS servers don't play well with loosing po...
Hi,Thank you for the update.We'll ook into the feasibility of implementing the workaround in the environment and the client must make a choice.What we did see though, was that when we failed over the HA pair to the standby unit the situation did impr...
Hi Kusan,Thanks a million,I specifically upgraded to the version for the 8510 that was selected as the Cisco 'golden image' . My understanding is that, that is considered the most stable at this time, or am I missing something??It's still doing it th...
