Re: DNAC in maintenance mode on CLI and not working

leighs · ‎08-17-2022

Hi,

Some guidance / Help please!!!

I have a DNAC appliance running ver 2.2.3.5. It unexpectedly lost power, and when it was brought back online it went to a screen where the last message was "Press Enter for maintenance (or press Control-D to continue):" pressing enter takes you to a maglev console prompt "root@maglev-master-10:~#" and nothing works - Pressing Control-D has no effect!!

How do I recover this appliance without reinstalling from scratch???

Any suggestions would be appreciated!!

marce1000 · ‎08-17-2022

- Do you have any other command options available such as ? or help .

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

leighs · ‎08-19-2022

Hi,

Yes, the maglev console still had commands but i had no idea which to run - I tried booting into Linux recovery mode and that broke everything - I'm re-installing from a flash drive AGAIN. Clearly these UCS servers don't play well with loosing power!?!?!