Hello, We ae using the ACS release 2.1 and we are migrating this server to the release 3.1, the problem is that when we tryed to migrate from 2.1 directly to 3.1 the database did not make it, i.e. we could not migrate the user, groups and netw...
Is it possible to do Authorization only in the ACS for windows 3.1 using the Acive Directory user database without defining the users manually in the ACS?
Hi, We have the following scenario, this company uses two methods for remote access (for employees only) : through RAS dial-up connections, or using VPN clients to connect to a PIX 535 through the Internet. We need to do accounting for the total con...
Hi, Is there any way to monitor the state of a VPN (i.e. up/down) using SNMP? which MIBS/traps should I use? Note: we are using a PIX 535 as a terminating point for all the VPNs.Thanks in advance
Hi, We have a network management console with HP NNM version B.06.20, and we need to monitor the utilization of the interfaces in several routers, two of this routers are 3640 IOS 12.0(5)T1. When we try to monitor these two routers all the interfa...
Thank you very much for your answer, as I review on the ACS 3.1 documentation a few minutes ago the procedure would be the same as you said, using version 3.0 as the intermediate.Best regards and thanks for your help
Thank you, I will try, but I have an additional question, when you do Authentication and Authorization, everything works fine because the user is dinamically mapped (and created) to the ACS group, but when you do Authorization only, it seems as if th...
Thank you Glenn, I review the bug notes and setup an alarm on it, meanwhile we will try some workaround as stated on the bug notes.Best regardsCarlos C.
Thank you, this link is excelent, but is there the same information available when we use a PIX as the end point? remember the local VPN termination point is a PIX firewall, and the remote point is administered by another organization.