Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have been doing several SD-WAN home labs with no issue but now I cannot get vBond/vSmart to connect to vManage. I was using version 19.2.3 with success but now in vManage when I click on Running Configuration for vBond/vSmart I see the followin...
I am having an issue with a lab I am doing and will my best to explain issue. I configured HSRP and a VPN connection on two router so my internet router can establish a vpn session. I see R1 as active HSRP and R2 as standby. When I ping the VIP addre...
I recently setup a Voice WLAN for customer that are going to use Vocera badges on their network. The issue we are facing is when one of the Vocera badges initiates a call we can see the badge is joining the multicast group immediately but we are not ...
So I got the connections established between vbond/vsmart with vmanage but still seems not working properly.
I do not see any omp peers on vbond and vsmart. There was one control up on v20.6.3 but none on v19.2.3. vbond shows no bfd sessions either. ...
mgoto,
Thank you very much for the response. The new configuration actually works on version 20.6.3 for me. Do you know if this new config style is for version 20.6.x and later? I was using version 19.2.3 with no issues until about a week or two ago...
Philip,
As promised, I would let you know if i got this to work. The one thing I forgot mention is I am using simulation software (eve-ng) with all my devices being devices. So, I got this to work using a C3725 router instead and now I am able to s...
OK either I am doing something wrong or could be a bug in software versions I am using (or both). I added the commands along with the other command I posted. R2 is still not showing as a standby connection and I notice as R1 became the active HSRP de...
OK I will see if this resolves the issue and I will also use ikev2. I will let you know if the issue was resolved or if I found a solution that works. I am using simulation software so not sure if this could be causing problems as well.
Thanks agai...
