Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Rakesh,
Reviewed your question and unfortunately, we did not have explicit SNMP MIB object to represent HW supported max BW.
The appropriate MIB object to represent interface BW are :
Interface speed : ifHighSpeed in IF-MIB http://tools.cisco.com/S...
Hi
The messages reported are due to the auto install feature. To disable this configure the command "no service config" and save the configuration. with this command applied you should not see the messages anymore when booting.
This command is docum...
Massimiliano,
Prime 2.1 is not yet completely integrated with LMS features. It is more towards Wireless features. So, 3850 wireless features are supported and is treated as a Controller.
Prime 3.0 is the right release for benefiting from Wired featu...
Frank,
The above messages are NOT service impacting. They are directly related to
SNMP and tend to occur if "IFMIB" is polled by SNMP while subinterfaces are
being added or removed and it stops after the interface being worked on is enabled.
This ...
Hi,
The following URL specified the supported devices sysOnjectId for Prime 2.1 release.
http://www.cisco.com/c/en/us/support/cloud-systems-management/prime-infrastructure/products-device-support-tables-list.html
Please make sure, your SW sysObjectI...
