Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,we have 2 ASR9010 IOS XR version 6.0 at 2 sites and would like to span 2 VLANs across the MPLS network using VPLS. The config is belowPE1 interface bundle-eth2.200 l2transportencapsulation dot1q 200 , 300l2vpnbridge group 2bridge-domain Span...
Hi All,Could someone help this please?In ASA cluster multimode ver 9.0, do the cluster control links need to be allocated per context or do they just require in system context? Regards,TaoLao
Hi All,We have an inline IPS 4260 (version 7.1(7), sig ver 719) that works for a while and suddenly stops passing http traffic through. All other kinds of traffic inlucing https are still passing through as normal. Stop sending traffic to it for awhi...
Hi All,We have managed to get citrix sso works using http and post option with parameters. However, we need to click the book mark link twice. after first click, we get a login prompt from Citrix server. Go back to the bookmark link, click again an...
Hi all, We have an output hierarchical qos policy on our WAN interface. Our Bc = 500 000bit/interval (25ms) Be = 500 000 . When apply the policy we see a lot of packet dropped. We remove it and reapply it number of times, then ask ISP if they see a...
Thank you everyone for your response.in the XR platform the tag will not be popped at ingress interface and the incoming frame with tag will be forwarded to PW. the IOS platform will pop the incoming tag and forward untag frame to PW.For the Xconnec...
Got it. Thank you Sujith and Subriyer. When I configure Data Link I have a message below. Do we have to do any special thing on the ASAN7Kinterface Ethernet1/6 switchport mode trunk mtu 9216 channel-group 20 mode activeinterface Ethernet1/7 s...
Hi Robert,I dont have a solution yet but when turned the unit to run in asymmetry mode, the unit seems to be stable. I initially ran into 100% inspection load issue then new firmware came out, upgraded it, ran into 99% missed packets issue. upgraded ...
thanks jcarvaja for the reply,I have not reset it yet as it might cause a downtime. I want to know if reset could fix the prob.i understand the implication of modifying the normalizer sigs but the sig1300.0 generates so many alerts that we could not...
