Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I would like to know if someone has an example of router config for a terminal server.In fact I need a configuration for a router with multiple, low speed, asynchronous ports that are connected to other serial devices, for example,modems or co...
Hi all,I would like to know if someone has an example of router config for a terminal server.In fact I need a configuration for a router with multiple, low speed, asynchronous ports that are connected to other serial devices, for example,modems or co...
Hi,My customer has a LMS 2.5 on windows 2003 server SP1 and would like upgrade Windows 2003 with SP2.Is it possible to do this with LMS already installed on the server ?If yes, what have we to do before (save the DB) ?Thank you by adavance.Best regar...
Hello,I have 2 6500-E configured in VSS and I have on each 6500 one ACE card and one FWSM card. My problem is that I have only one ACE card OK and the other in PwrDown or Other status at the same time. There are never the two card in OK Status at the...
Hello,We configured two 6500 with VSS and it's working well, but my customer has HP OpenView and would like to see two 6500 nodes on his map. In reality he would like that each 6500 has one IP address (one ip address for each 6500 like a loopback IP ...
Thanks,Yes, you have right, in a VSS design there is only one Sup card in active mode for the two cat6500. My problem is how I know when one Cat6500 become down ? I would like to view the two Cat6500 on a HP OpenView map with two node, when one cat 6...
hithank you for your answerI don't know if cat 3750 with IP SERVICES ios support this image, so If I cannot use Fast Hello I heard that it's possible to configure manually hello to 1s and Dead interval to 4 * hello = 4sDo you confirm this ?What are t...
Hi Leo,Thank you for the answers.Effectively I'm agree with you but I don't understand why on the document "Spanning Tree Protocol Root Guard Enhancement" it's specified that we have to put this command on all port where the root bridge should not ap...
Hi,You cannot "trust" the CoS and force the CoS at the same time.You have to choice between trust or force the cos.In your configuration, you have to remove the command "mls qos trust cos".If it is possible, try to force with DSCP and not CoS with th...
