Hi, I am looking for the way to define an idle timeout for specific flows on an ASA5580 by using Cisco security manager. For ex I needed to define a specific idle timeout for connections beetween specific devices (Devices in vlan1, Device2 in vlan2). To test it I did following changes by CLI and it works fine.     access-list L1 extended permit ip <@IP1> <mask1> host <@IP2>     class-map CM1         match access-list L1     policy-map PM1         class CM1         set connection timeout idle 02:00:00 I try do do the same configuration with CSM in order to be able to manage each changes only by using CSM. So I defined  Access control list, Traffic flow and then I define timeout in CSM --> PIX/ASA/FWSM Platform --> Service Policy Rules  --> IPS, QoS and Connections Rules -> connections settings -> Traffic flow idle time-out. The problem is that each time I deploy the configuration with CSM I loose the timeout config line which is the most important for my application... Can you help me? Thanks, Murielle ... View more

Hi I use a C2950-24 switch, with IOS 12.1(22)EA12 release. When I try to connect in console mode, I can see the "Press RETURN to get started!" message, but it's not possible to me to have the # prompt. An "authorization failed" message is displayed. And the same message is prompted. I try to recover password by following the recovery procedure. After the boot command, I never see the message "Continue with the configuration dialog? [yes/no]: ". How can I solve this problem ? Thanks ... View more

Hi since the PC are managed by NAC, some users met problems with the "host" file (file empty). Does the NAC agent have any influence on this mechanism? Is it possible to reload this file? Thanks for your help ... View more