Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Do you know if it is possible in ACE 4710 appliance to configure a SIP TLS probes?The SIP probe we have in the configuration guide it is only for clear text. Anyways, for Lync 2013 we need to establish first a TLS session and then within i...
Hello Forum, I have 2 basic questions I am having doubts about it and would love to have some clarifications: 1) I configure in one ACE4710 (running 4.2.2) context a bridged interface and in another context the same interface, like here below :---- ...
hello,We are doing Load balancing of MS ISA servers SSL ActiveSynch and from time to time they go down for reasons not known yet.We configured a TCP/443 probe which does not fail when these ISA server go down and consequentially we have FAILED connec...
Hello,I need to configure a out ACL in the vrf contect management.How to do that? I miss it..DS1-R101(config-vrf)# ? ip Configure IP features ipv6 Configure IPv6 features no Negate a command or set its defaults shutdown Shutdo...
thanks!but what about simple traffic redirection using the 0.0.0.0 catch-all rule? we need just to discriminate HTTP traffic from the other traffic without checking the source IP address.would it be possible?
Thanks for your valuable answers.About point 4), its very interesting what you say but I am not sure that it will work using a L-3 etherchannel.If you see the 2 animation slides, I am fraid it may create a Black-Hole of traffic when u use a Etherchan...
1.- But can you confirm that in a multi-layer vPC the vPC domain IDs must be unique on the 2 different vPC domains? If 2 N7K have "vpc domain 1" and they are connected to 2 N5K, the 2 N5K cannot have as well "vPC domain 1", right?2.- I opened a case....
I have 5 questions I hope you can enlighten me about:If I do multi-layer vPCs (or maybe its called back-to-back vPCs), does the vPC IDs that you associate to the interfaces must be the same on all facing-swicthes or they just have local important to...
Hello,Thanks. I upgraded to A2(3.2) but still the same issue as shown in the attached commands.I am using a ACE module 10, not the appliance but i guess it should be the same.Thanks for your help.Giulio
