Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I'm in the process of deploying a 5k and 2k environment in my DC. Currently have a pair of Nexus 7K's with a CORE an DSTR VDC. I'm trying to see what the benefit is of taking an SVI and making it my "management interface/IP" to access the two ...
I have a VPN tunnel created over an ASA 5510. We are not doing any NAT'ing and allowing all subnets from both sites to communicate with each other. Only issue we are having is users that have VPN Client on the remote side are not connecting/communica...
Hello,I'm using a Cisco Concentrator VPN 3030. I have an existing VPN tunnel where i'm making Static NAT entry's for a local IP subnet and only using the NAT'd address for the Local Address list.The NAT subnet is a /29Problem is I need to add 2 new S...
Hello,Not much firewall experience so looking for some assistance. I have Pix 535 running 8.0 in single context mode. I created Multiple sub interfaces for my guest users. Each interface is a separate subnet with a security interface level of 90. I a...
Hello,I was looking for some help or advice or maybe a link to point me in the right direction. I"m having an issue with switch link going back to my router that is experiance a lot of transmit discards. I was hoping for some help into what causes th...
So I have a site to site VPN tunnel with us and another customer. They have users from our company at thier location. They control thier own Firewall and location. We just route thier subnets and they do the same and route ours. We orginally had our...
I'm not routing the /29 through my network. But through the tunnel I do have the network list setup as the following10.1.1.0 0.0.0.7 as part of my network list. I have this on my local list and they have that on thier end as thier remote list. The o...
1) Yes I say it's def. worth upgrading to the latest IOS. Probably corrected bugs from the older version2) Yes they both must be running the same IOS/Image3) Not a 100 percent sure on this. You are probably better off opening a ticket to find out.
I don't believe it's an STP. I did verify that. I'm pretty sure it's an issue with the Memory as I went back to a Logger that we have and it is reporting issues with the memory. I'll really get my answer when I replace this switch tomorrow and See if...
