Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,form my understanding (and reviewing BRKCDN-5044 from Orlando) there are is a fixed list of variables which can be used in templates. I Think the same (or quite similar) variables/values are written into the database on device inventory. For i...
Hello,does Cisco PI provide an API to access its data? We have a list of ip addresses with correct timestamps and i want to know which user had the ip address in the corresponding timeframe. Is there any way to accomplish this?thanks for any response...
hello,we plan to upgrade vom 2.0(d) to 2.1(d) and when going over the current configuration i see that 2 VSANs have default zoning enabled and 1 VSAN has default zoning disabled.we are running end-host mode, so from my knowledge the default zoning be...
Hello,is it possible to change the columns in the kvm launch manager. Right now our users just see the service profiles and other stuff there, and they have no idea, which server is "behind" the service profile. we use the "User Label" to point to th...
We have a brandnew UCS and upgraded to 2.0(2r). Now we do have a problem with launching the UCSM and the KVM tool. The problem is not the https certificate (we installed a commercial one), this one works. but when launching the java web start tools, ...
Hello Robert,i thought/hoped that i get an answer like this. I do not have any directly attached devices nor we are running fc switch mode. I just wanted to get sure that i am not affected.thanks and regards-andreas
we have never opened a tac request. we are in a large project right now and dont have the time to debug this issue. if you have a solution, please post it here.which CA / sub authorities are you using? regardsandreas
I do have a problem with this blade type (mlom 1240), too.After downloading the driver package, there is just a readme that xenserver 6.0.2 includes the driver already. dmesg shows that fnic and enic modules are loaded and working.I have configured z...
