About Javiermo0

Javiermo0 · 08-12-2013

Hi!!I want to share with you a problem that I found on this switch (Firmware is 3.0.2.0)1) After i saving DHCP Relay Settings i reboot the switch and the settings are not saved, all others settings are ok but DHCP Relay settings are lost after reboot...

Javiermo0 · 05-21-2013

Hi, it is my first post, sorry but my english is very bad!!! I want to know how am i do to change the Vlan1`s IP address because the actual ip will be used in another vlan. Actually i haver 10 vlans in L3 mode (routing) implemented in it.I hope you u...

Javiermo0 · 08-12-2013

Thanks Tom!! All configurations are saved ok but not DHCP Relay settings. I am trying using Firefox and IE... same result!Any idea?

Javiermo0 · 08-12-2013

You must to Copy Running to Backup config first an then Backup to Startup config!!! I almost went crazy with this issue but i solved in this way!!best regards

Javiermo0 · 05-22-2013

Great Tom!!! I will try it!! I did not know that there was a CLI (LCLI) in this switch, I understand that is the only way to make the change I need, is not possible with web interface!!. I learned something new! It was very useful reply, Thanks!Best ...

Javiermo0 · 05-22-2013

Thanks Tom!! But the idea is ONLY change the VLAN1 IP address by ANY other IP that I want. If you go to Interface IPv4 setting panel is possible to change the IP of existing ones via a dropdown menu but I can not type any IP, i can only choose IP of ...

Member Since	‎05-21-2013 03:38 PM
Date Last Visited	‎08-18-2017 04:00 AM
Posts	6

User Statistics

User Activity

SGE2010 can´t save DHCP Relay settings

SGE2010 change VLAN1 IP address

SGE2010 can´t save DHCP Relay settings

SGE2010 - Firmware upgrade and config not saving

SGE2010 change VLAN1 IP address

SGE2010 change VLAN1 IP address