Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have an installation with a UC320W and 8 phones (most are SPA504G). This has been in place for one year and the infrastrucuture is new with separate CAT6 cabling for the voice network. On two occasions we have lost the ability to make intercom call...
We recently completed an installation of a UC320 in a public library. One phone has been located in the lobby to allow for emergency calls when the meeting rooms are in use but the building may be closed and not staffed.Trying to make the dialing of...
In the process of deploying a UC320W and we have a need to have two analog phones connected to the system. Is it possible to connect both phones to the FXS port and allow them to share an extension? These phones will have very limited function and ...
Getting ready to deploy a UC320 and thought that the Pre-installation Workbook would be useful. However, it's only available as a PDF document which would need to be printed and filled in by hand. Any possibility this can be made available in a Wor...
Hello,I've been running my demo UC320W in my lab for several weeks while I fine tune a configuration that I intend to deploy in two weeks. When the RC for firmware 2.2.1 was released I installed it with good results. Earlier this week I installed t...
Hello Julio,Thanks for your reply. Regarding building a new config from scratch, I was leaning in that direction and appreciate the confirmation that it is the best route.One item I did not account for in my test lab; have a 10/100 switch that is of...
Scott,Is your macbook older? Surprised it does not support WPA2 but WPA is more secure than WEP.Don't have any advice for the MTU setting; for the units we've deployed we've always used the automatic setting for this.Mark
Hello,Recommend using the default settings for most parameters and only change them when you have reason to do so.Don't know of any tutorials, but you can try the online device emulators; since one does not exist for the wrv210 you can try one for a ...
Hi ScottThe firmware upgrade will most likely help with some of your issues; we saw good improvement with the 2.x versions of firmware. However, the overall reliablity of the wrv210 has not been good and we stopped deploying them some time ago (we s...
Scott,Navigating the Cisco website can be a little daunting at times. Here's a link to the firmware: http://www.cisco.com/cisco/software/release.html?mdfid=282414014&flowid=788&softwareid=282463177&release=2.0.1.5&relind=AVAILABLE&rellifecycle=&relt...
