2 analog phones on FXS port

[markfurlong]

In the process of deploying a UC320W and we have a need to have two analog phones connected to the system.  Is it possible to connect both phones to the FXS port and allow them to share an extension?  These phones will have very limited function and use; they will be setup as "hot phones" to call the front desk only and will not receive calls.  I prefer not to purchase a SPA8800 just to add one analog line.

Suggestions and comments would be appreciated.

Thanks,

Mark Furlong

[Matthew Needs]

We've done this(Plan1A) with tonnes of PBX's in the past.. Never had a problem. As far as the UC320 goes, I cant see it being an issue either as an FXS port is just a standard analogue interface.

Just remember that only one phone can be used at a time and that both phones are effectively the same extension.

Hope it helps

Matt