Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm wondering if the acs can in some way read a custom per-user attribute that the ldap server is sending. As far as I know the attributes are only per-group, because the acs asks the ldap server about certain user id and the server looks for the...
Hi, I still have to understand what Cisco means with the terms max throughput and wire-speed.Example: I have a 1841 and soon I'll have to set it up for 200m multicast traffic. How do I know if the 1841 will be able to support that traffic?Is there a ...
Hi,I configured a remote-access vpn on an ASA 5510 version 8.3. This is the configuration............tunnel-group prova4 type remote-accesstunnel-group prova4 general-attributes address-pool vpnpool1 default-group-policy test_vpnpool1_policytunnel-gr...
Hi, I have a lan2lan between my asa 5510 ver 8.3 and another device, see the attached scheme. The other side would like to reach all my local lan via telnet from their PC-A. They can actually reach the devices inside the lan e.g. 192.168.1.1 and .2...
So is it that simple? if I take a look at that table the first router that can handle such traffic is the 2921, are there other factors I should take into account?
I followed the guide and copied every configuration, but I still have the same problem, the firewall does not encrypt the traffic towards my client. I add a screenshot after the new configuration. I hope someone can tell me what to do, thanks.
I corrected my configuration, but maybe it's better if I start again from nothing.Can you post a simple configuration for a remote access vpn using cisco client? I just would like to be able to access my devices in the inside interface at ip 192.168....
There's management-access inside, and there's a route in the routing table for the ip address of the vpn.However I think the key of the problem is that the firewall does not encrypt the traffic back to my client.Could it be a problem of the client ve...
Hi I still can't connect, if you take a look at the output of the asdm you can see that my firewall does not encrypts packets out!What could be the problem?
