Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an MPLS network router(Router1) and an internet router(Internet1) at a site of mine(Site1). the MPLS router sends all unknown traffic out the internet router. Router1 is the default gateway for all hosts and directs the traffic. I also have an...
I am seeing the receive load of my S0/0/0 interface reaching 90% or higher during normal business hours of an 1841 router in an MPLS network. The traffic seems to be bursty as the morning is in that 90% or greater range then an hour before noon it ...
Hello all,I am used to setting up access-lists on outside interfaces with ip addresses that are static. I have recently been given a site that is using a dyndns.org client for name to ip address resolution on an outside interface that is dhcp assigne...
Hello all,I have recently implemented a disaster recovery solution at my headquarters site. I am running an mpls network and have several branch offices connected via the mpls.The datacenter which hosts our disaster recovery equipment has a 3Mbps cir...
Hello, I Have 4 cisco catalyst 3550 switches. I am attempting to find the access port through which a particular ip address is coming through. What commands can I use on the switch to find this information and trace the ip address to a physical port....
Jennifer,I am not able to telnet to port 41794 or 41795 from the outside. When I do that I see a syn timeout on the ASA log.It is possible that more ports need to be opened however this ASA was a replacement to a Sonicwall TZ 180 and that device only...
Jennifer thanks for the reply. DDNS is working ok through a client on the inside network.The issue is being able to access an application running on ports 41794 and 41795 from the outside. When on the inside the application runs but when beyond the L...
Dominic, No errors appear in the DC. Eventually there is an error message but it is the typical timeout message as if no DC exists. Would you like to see the PIX config?
I will give this a try. Do I also need to configure the group before or does the vpngroup GROUPNAME user-authentication command do that for me? Thanks. I will rate.
