Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a need to connect a Nexus 93120TX to (2) Nexus 9504's. The 9300 is located about 2 miles away from the 9504s. Site A has the (2) 9500s and Site B has the 9300. Throughput requirement is 10GigE. Here's the challenge, as of now, there is only a...
I think I may need a mobility anchor, but I've never used them in production, and its been awhile since I've used them in a practice.
There are 3 sites. Each has its own WLC (see below for WLC specifics). There is a specific VLAN/Subnet/WLAN that o...
Hi,
I've recently upgraded two edge routers used for BGP, from 2921s on IOS 15.0(ar)M15 to 4451s on IOS-XE 03.13.02.S
I use BGP prepending to influence inbound routing from my ISP (each router has a dedicated circuit to the same ISP). Using the old h...
I've been tasked with designing Internet redundancy into and out of our network with our single ISP (I know two ISPs would be better). I've been doing some research and thought I had a good grasp on things, but now I'm confused on a few things. Lots ...
We will be getting a circuit from the same ISP at two of our sites and will be doing eBGP. Couple of notes. 1. We are fully aware of the risks associated with depending on a single ISP and have mitigated them as much as possible with the ISP. 2. We ...
Andrew, I don’t have a direct answer for you, but check out these two posts if you haven’t already. Not exactly the same, but similar enough they might provide some insight. https://supportforums.cisco.com/thread/150843 https://supportforums.cisc...
Hi Smitesh,Thank you very much for your answers. That really helped clear things up for me.I know what you mean about #4 being tricky. Maybe its my lack of in depth understanding of BGP, but I’m not sure that even if I were advertising the routes v...
