Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have a 3502 ap connected to a 2100 WLC, I want to create and SSID with wpa/wpa2 with psk authentication. Cisco duomentation shows that it is not possible as it fllas back to 802.1x auth.is there a way to create an ssid with psk and a spla...
Hello All,I am looking on the difference between type 2 n connector and type n connector?is the 1552H outdoor access point need special fitting for the AIR-ANT5114P2M-N antenna? Thank you
Hello All,I setting up an outdoor wireless network and need some help please.Will be using 1552h access points.For VoWifi coverage are we limited to one hop back to the RAP?With a clear line of site what is the distance between each ap for backhaulin...
Hi All, I have a couple of question in regards to rogues and rf grouping.Does the controller count the rougues access points when calculating channels assignments in the network?The current setup has each floor in a separate RF group, does the APs in...
Hi, I am all new to this. I have a stand alone 1140 AP and i am trying to perform a site survey using the AP; However I dont know what configs need to be on the AP for the survey ? can you help me please?
boot your switch and use the following:Enter configuration commands, one per line. End with CNTL/Z.Switch(config)#line conSwitch(config)#line console 0Switch(config-line)#speed 9600( change your baud rate on ur putty back to 9600 after this command ...
So Static channel assigment is recomended? is there any documentation that support this ?there well over 300 APs and static would be not pratical! unless assigne static channel to the APs arround the microwave areas, if so would the controller use th...
Does the controller count the rougues access points when calculating channels assignments in the network?Depends on the RSSI values. If the RSSI is strong enough, then yes. Would this be the same for microwaves that have a significant leackage...
