Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This issue is carried over from firmware version 1.0.3.59. The LEDs in the System Summary screen (under Status and Statistics) do not match the physical LEDs on the front of the switch.Screenshots:1.2.9.44 (LED indicators function perfectly)1.3.0.62...
I installed the 1.3.0.59 on a couple of SG300-28Ps. On the Status and Statistics page, the PoE indicators no longer lit. Physically, on the front of the switch, they did still light. I didn't yet reboot to factory defaults to see if that clears it,...
Hello, I have SG300-28Ps as the PSE's for my IP telephone system. The phones are tagging their voice packets as DSCP 46 as directed by auto voice vlan. The QoS settings on the switch are at default - Basic Mode, Trust DSCP, strict priority, etc.On ...
I use PuTTY to SSH into Cisco switches regularly. Today I ran into the message 'incoming packet was garbled on decryption'. I logged into the switch via HTTP and saw the uptime was 115 days. After seeing I could PuTTY into the SG-300-28P right above ...
I recently started upgrading our small business line to image 1.2.5.70. This includes an SG300-20 and five SG300-28P 's. The first thing I noticed is that the switch applies port power well before the switch has finished booting and is forwarding fr...
I'm sure someone can correct me if I'm wrong. But I think the reasons are as follows.-These are small business switches, not Catalyst switches. For a reason. They are marketed for small businesses and to be set up by techs not necessarily Cisco tra...
Hello Chris,Cisco has ackowledged this defect and plans to fix it in firmware version(s) 1.5.x.x. Chances are this will be the next build that comes out.Kind Regards,-Brayton
Hello Jiamin, Thank you for your reply. You provided confirmation that it is an known issue and that a fix was planned, which is all I was looking for.Kind Regards,-Brayton
Hi Chris, I decided to try your procedure, except I used release 1.2.9.44 as my roll back. This was a good release for me. I found the smallest SG300 series switch with the simplest config and did the following. (I took screenshots too just to prov...
Thanks for letting me know about this release, I only checked it out because you mentioned it. I tested the image and can confirm that the PoE status indicators are not fixed (in System Summary area). I'm actually quite suprised that this bug is pres...
