Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,In cisco document it is mentioned that to work as XL, all card in chassis must be XL (apart from scalable license requirement). Is it a chassis or vdc specific requirement?In below case we have create two vdcs in one n7k switch and installed th...
I have been facing problem with POE ports( port 7 and in 2106 WLC. I have connected AP 1142 on port 7 of 2106 controller but it is not comming up.Bewlo is the command output. Not sure why the port is in power off mode.(Cisco Controller) >show port ...
Hi,I am getting a very strange problem where 4500 switch is remarking the packet with dscp 1 to 0.Let me explaint the setup. I have two PCs connected on same switch but on different modules. PC1 is conencted to Gi4/19 and PC2 is connected to Gi2/43....
Can somone please explain how the AVF are elected in GLBP? I mean if we have 5 routers in the network then which router will be in backup mode and how the active forwarders are elected?
I can see you have selected AR - Argentina country in your WLC whereas your AP model is for America.Please select the America as well in wlc option. It must be in controller tab.
no success ;-(Still the port are in power off state.(Cisco Controller) >show port summary STP Admin Physical Physical Link LinkPr Type Stat Mode Mode Status Status Trap POE -- ------- ---- ------- --------...
yes, I have tried another working AP on the POE ports but it didn't get power. Why the POE status is power off? Via power injector it just work fine. Something is wrong with the POE ports not why WLC is not providing power to AP.
Used the command no qos rewrite ip dscp on both interfaces and now getting the correct values. But still not sure why only it is impacting the non standard dscp values. Investigating more and will update the post after getting the solution
