Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to open a discussion on spanning tree issue which I am experiencing on my network.When I am ready to "Post" I am getting the following error "Correct the highlighted errors and try again."However, I don't see any highlighteed errors at al...
I want to distribute only one static route to OSPF.ip route 10.55.254.0 255.255.255.192 10.80.60.5 My config:ip prefix-list DMZ201 seq 10 permit 10.55.254.0/26route-map DMZ201-TO-OSPF permit 10 match ip address prefix DMZ201 router ospf 200redistribu...
I need to add multiple new stacks of 2960-X to the existing network. However, two existing 4500-X Core switches (in VSS) have no ports available to connect these stacks.
I have another set of 4500-X which I want to connect to the Core as an aggregati...
I would like to create static route at one of my location's core switch and point it to the firewall (route is for one of the public IPs. I am running EIGRP on the core and then I distribute routes into BGP to my WAN.
I don't want to redistribute all...
HiI connected ASR1001-X to C3850 which runs OSPF already. C3850 successfuly works OSPF wise with 2 other C3850 over VPLS (broadcast type OSPF) and with directly connected SonicWall. ASR1001-X Gi0/0/1 is connected directly to C3850 Gi1/0/1. Both are r...
