Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI'm about to do a migration from a cluster with X1050's and we are moving to X1070's. To plan for the migration I need to compare the out-of-cluster X1050 configuration file with the equivalent X1070.If anyone could kindly remove an X1050 from the...
The Critical message is:ISQ: [notification] Fail to send notification. Please make sure HTTP access to ISQ is configured.The Ironport Spam Quarantine is not enabled and there are no policies configured to use the ISQ. What cuold be causing this aler...
Thanks KenIn a perfect world this is exactly what I would do, however there is no rackspace available, so we must remove a single appliance and then add a preconfigured X1070 with identical IP address into the cluster.There will be only subtle differ...
Obtaining Metrics for my customers is something which is quite confusing, given every different vendor uses different metrics. What is the UNIX command to show HTTP request per second, and is there some documentation on how to use this figure to siz...
KrisI wouldn't recommend turning senderbase off, as it the strongest engine within Ironport and also the most accurate. To achieve your desired result, you should add the IP address of your mail server to the whitelist in the HAT table, however you ...
GuysISQ had not been enabled on any of the interfaces, so I doubt that was the problem. However, ISQ was actually enabled, something which must automatically be enabled during the wizard setup, although I do not use the spam quarantine. It's now di...
I had the same issue...and there is an article about in in the knowledgebase.Use the localeconfig command via CLI and accept Y for all options. It's to do with mismatches with encoding and running that command will force the footer into the body.
