Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I´m doing a design for presale, where I will need a router what support PAT for 500 or a little more of users, it not need any more features only static routing and dhcp pool for 500 users, can you help me for know what router recommend?
Hi everyone, i have a weird problem and i hope you can help me guys!! I have just migrate a Symbol-based autonomous wireless network to a Cisco Controller-based environment and everything apparently was working fine. However a few weeks later the i...
Hi, I have a problem with a 4402 Wireless LAN Controller running 7.0.116.0 versión. The equipment is working fine, but after a hard reset i lost date and time configuration.No other configuration is affected, only date and time. What can be the cause...
Wy CNR version 6.2.3.1 has been retired? Is it becase this version has several problems? I have an issue with this software and wonder wy I can not dowload any more this CNR version.
hi!!! everybody...somebody help me?l have a extrange problem... l have a hunt pilot with a group of secundary extensions that when they recived a call from extensions 78XXXX (from IVR) they can answer them but when they want to tranfer them to anothe...
No, I don't Amjad. When I was troubleshooting I discovered that, when with an autonomous AP, the only traffic was Netbios and I had access to server's folder. On the other hand, when I was testing with lightweight infraestructure, I didn't see any t...
Hi Amjad, I issued the command config network broadcast enable and this apparently solved the problem, I don't know if this will have further consecuences, please let me know if there's something and thank you very much for your assistanceRegards
So, do you think this is a hardware problem? Because as you say, i have rebooted several controllers in the past and i have never seen this... I will test with an NTP configured, but if this is a hardware problem i have to take actionThank you all
