Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,a simple question regarding the general availibility of the BE3K in Canada for resellers? There is much anticipation and interest for some time in the community and accurate information is hard to come by.Any ideas please?Thanks!!Yan G.
Hello, we are trying to decide on which router in the SMB line would support the above speeds on the WAN?The datasheets provide NAT throughput info but I am not sure if that is enough to make a decision.The RV180 series seems to offer NAT throughput ...
Hello,I am using CCA 3.0 with UC520 and cannot transfer call to a user with analog FXS port.The call simply ends up in voicemail after many rings.The actual phone works and can even make call during the actual process.What can be done?Is the a config...
Hello,reading off this forums it seems there are many approaches to setting up dual WAN's on a ISR.This is a very common scenario and would be nice to obtain a clear answer.Clearly, this cannot be done with static routes I believe.I read about IP SLA...
Good day,We are looking for an updated and simplified approach towards upgrading the UC500 (AA, voicemail, endpoints etc) to dual language.I have requested this a while back but it seems the procedure is too complex and possibly outdated.https://supp...
So from further investiagtion, I believe that Policy Based Routing using NAT Load Balancing is the best way for this.Can this be configured through CCP ?Thanks
French Canadian. I have all the localization files I believe but do not know how to instruct my people what to do with them.Is it easier to completely wipe out the flash and have the French loads only?Thanks
