Hi, I know that Auto-MDIX On or Off can be verified by "show controllers ethernet-controller gigbitethernet 1/0/x phy”. I'd like to know how to verify MDI/MDIX status of auto MDIX port on Catalyst2960X.
Could you please let me know conditions of this defect? Is dropping CAPWAP packets between WLC and AP a condition of this defect? Is MTU < 1500 bytes link between WLC and AP a condition of this defect? Best regards,Yasuhiro Ujihara
Hi,
From Bug Search Tool, CSCub92025 was fixed from 15.3(2.4)T.
I would like to know whether IOS15.3(3)M1 is affected by CSCub92025 or not.
Could anyone let me know this?
Best regards
Hi,
I encountered contituously Tunnel interface down symptom during DHCP renewing.
Could you please help me to avoid Tunnel down symptom?
Condition:
-----------------------------------
Hardware: CISCO892-K9
Software: IOS 15.3(3)M1
Topology
------...
5700 シリーズワイヤレスコントローラは、システム MTU の設定値を超えるフレームを受信しても、受信ポートで破棄をするように設計されています。
このようにフレームが受信ポートで破棄された場合は、通常はポート LED が橙点滅(Blinking amber)します。
フレームが破棄されないように、5700 シリーズワイヤレスコントローラのシステムMTUの設定を変更するには system mtu <bytes> コマンドを使用します。
設定例)
CT5760(config)#system...
Thanks.
BGP is the routing protocol over the tunnel between CISCO892 and ASR1002-X.
BGP on ASR1002-X is advertising 0.0.0.0/0 through the tunnel.
ASR1002-X is a HUB of IPSEC tunnel and CISCO892 is on a branch office (a spoke).
Best regards,
Y...