Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,My IPSEC tunnel regulary doesn't work, and the only way is to reboot the SA520 ...Is it possible with a batch or something else to auto reboot the SA520 ? Thanks !
Hi, i just received my UC540 and try to configure the sip trunking.SIP outgoing calls are ok, but not incoming ...when i active the debugging, the logs shows me : 003312: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore: Calling Number=3397999447, Called Num...
Hi,Can you tell me please if a AIR-LAP1141N-E-K9 can be configured in stand alone mode, without any controler.In the datasheet : • AIR-LAP1141N-x-K9 - Single-band Controller-based 802.11g/nThanks
Hello,I actually use an SPA2102 with 2 SIP accounts. The first one, on the line 1 use QOS by tagging RTP packets :Network SettingsSIP ToS/DiffServ Value:SIP CoS Value:[0-7]RTP ToS/DiffServ Value:RTP CoS Value:[0-7]Network Jitter Level:lowmediumhighve...
ok, I just finished my test.The config :QOS QDisc:NONETBFMaximum Uplink Speed:(Kbps)Network SettingsSIP ToS/DiffServ Value:SIP CoS Value:[0-7]RTP ToS/DiffServ Value:RTP CoS Value:[0-7]Network Jitter Level:lowmediumhighvery highextremely highJitter Bu...
I put the TBF policy, but nothing has changed :09:24:04.336114 IP (tos 0x0, ttl 250, id 25766, offset 0, flags [none], proto UDP (17), length 200) x188.149.115.16444 > 212.155.135.209.9142: UDPand another one, on the same network , same configuration...
ok,The 1000 SPA use :Software Version:3.3.6Hardware Version:1.3.5(a)and some of them never put the RTP tag.I am going to try to put the qos policy on my spa to see if it work but i only have the TBF option (no CBQ)I don't understand : Set the debug l...
Thanks a lot for answering,My wan parameters :QOS SettingsQOS QDisc:NONETBFMaximum Uplink Speed:(Kbps)In fact I only want to tag RTP packets, on line 1 and 2. I don't want to limit upload speed.I don't understand why it work on the first line, and no...
