Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, just a quick question about best practices for an ASA5520. I'm currently running a pair of these as internal firewall for my organization, and have about 750 rules dictating traffic. A lot of the rules are for individual ports to specific server(...
Hi, I've recently set up a guest wireless in my office, using a WLC 2504 controlling 4 1142 APs. They have been working great for about a month, but as of yesterday, the Wifi signal from 2 of the APs began to pulse - 5 seconds on, 1 second off - whic...
Hi there,I'm currently using LMS 3.2 to monitor my network. We've recently purchsed a few of the Cisco Small Business Switches, the SF 300-24 model to be exact. They're considered 'managed switches' (tho thier CLI is terrible) and I would like to mon...
Hello,I have a problem with applying User Created Templates in RME. I can create them fine - One Task, with multiple Templates below it (the two templates are identical, save for a single IP).When I create the job, I select the appropriate devices an...
Hi,I work for a retail company, with about 700 sites. We are currently in the middle of upgrading the equipment at the store level, and this requires a new configuration to be sent to the router on site.My colleague has created the 700 configuration ...
When I say pulsating, I'm speaking in regards to the WiFi signal of the AP 1142. The signal comes up for about 5 seconds, then disappears. After a second or two, it's back, but disappears again. All of the APs are set at power level 1, and nothing el...
Thanks Marvin. Do you know if these devices support SNMP traps? And does the FindIT deal with them? I'm trying to monitor these as I would a regular switch on LMS 3.2 for example. I know it's a much toned down version of the IOS/CLI, but I'd still li...
Thanks for the explanation, but I just want to be sure that I understand correctly - anytime I run a Task, ALL Templates under that Task will run as well? I cannot select a specific Template within that Task?If that is the case, why have the ability ...
