Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As part of a large scale MX rollout I've been working with the Dashboard API to add/remove, bind/unbind devices. There are a few pieces to our process which I've not found API access to, and was wondering if they're available via another API or are s...
I have an interesting issue where I am seeing high output queue drops between two servers on the same VLAN.Servers are 1Gb attached and speed/duplex has been verified. The servers run around 40-50Mb/s and then burst up to 150-300Mb/s. It is during ...
Since upgrading to the A2 code from the 1.6.3 code you must apply inspect ftp on a layer 3 class.This has broken my outbound NAT when using FTP, and I'm wondering what the workaround is. In A2, all of the 'inspect ftp' statemens below are invalid. ...
I am curious about modifying ACLs associated with an outbound distribute-list.Upon making modifications to the ACL (ip access-list XX permit xx.xx.xx.xx) is it normal behavior for the peers to flap (distribute list is attached to a named interface).I...
Ok, I'll preface this by telling everybody that I _know_ how poor a configuration this is, and this is why I've been brought on; to redesign the network and make the transition as smooth as possible.Network currently consists of flat vlan (Vlan1) wit...
The issue appears to be related to CoS 0 traffic being dropped by WRR on the interface.This only occurs during a large burst of traffic on the interface (which occurs regularly due to a scheduled batch job).There is no other traffic going to the serv...
OK, but how do I apply that on the outbound NAT, which is matched against a Layer 3 ACL? (I also noted I could not create Layer 4 ACLs after upgrading)
That much I understand, but I am trying to apply this on an outbound NAT policy, not a virtual-server VIP policy. I've been able to fix the FTP inspection on the VIPs in the manner described, but this does not help me for the outbound NAT connections...
What about FTP where the server is behind the loadbalancer and is NAT'd on the way out...The config below works in 1.6, but in 2.0 train I get a message: Error: This class doesn't have tcp protocol and a specific portSince upgrading I can't seem to c...
Thank you both for your input. I was shocked to find that a widely deployed routing protocol would require a complete reset for a new network announcement; it's 2007, i guess since everybody has redundant gig links everywhere this isn't a major conc...
