About robertbradleycombs

robertbradleycombs · 07-08-2015

Hello,I have an ASA 5505 with the security plus licence and a catalyst 3750G. I'm fairly new to this so please bare with me.I want to setup a network with multiple VLANs, some of which can communicate freely with each other, some of which which can o...

robertbradleycombs · 04-04-2015

Hello, I have 2 WAN uplinks: The primary is VDSL (PPPoE) - very fast, and I have a static IP + /29 subnet 'assigned' to me.The secondary is DSL (DHCP) - slower What I'm trying to do is setup ISP failover on my ASA 5505 with security plus licence... a...

robertbradleycombs · 03-04-2015

Hello all,I apologize in advance if this question is very simple or difficult to explain as I don't have any formal network training - but I am a fast learner :).Here are the main elements of my equipment (this is a lab environment, but I'm trying to...

robertbradleycombs · 04-09-2015

I figured it out. In the ADSM, I went to Configuration > Interfaces and edited the outside-backup interface. Obtain default route using DHCP was of course selected, but I noticed 'DHCP Learned Route Metric' was set to 1. When I changed it to 2, every...

robertbradleycombs · 04-06-2015

Hello, I checked my config and I don't have that command on either of the outside interfaces, just my two inside interfaces (inside and trusted_4). rbcutm# sh run | i ip verify ip verify reverse-path interface inside ip verify reverse-path interfac...

robertbradleycombs · 03-08-2015

Hello Jon,While troubleshooting, I lost access to the ASA and had to do a hard-reboot... and after it rebooted - EVERYTHING works!!The switch is routing VLAN10,20 and after adding:#http 192.168.10.0 255.255.255.0 insideI can access the ASDM!! Looks l...

robertbradleycombs · 03-08-2015

Hi Jon,Sorry - I wasn't clear. The initial tests were directly connected to the ASA, but the others were from VLAN10 (I set a static IP). I'm unable to hit the internet (traceroute results above where from a client connected to VLAN10 via static IP)....

robertbradleycombs · 03-08-2015

Ok, so we're getting somewhere..slowly!All the VLANs on the switch (VLAN10,20) can communicate with each other.The 'inside' interface on the ASA (which is still on VLAN1 as that was the default when going through the wizard)..Right now, my machine is...

Member Since	‎05-29-2013 03:35 AM
Date Last Visited	‎08-18-2017 04:00 AM
Posts	11

User Statistics

User Activity

Multiple 'security zones' - ASA and Catalyst 3750G

ASA 5505 ISP Failover (PPPoE/DHCP)

L3 inter-VLAN routing - ASA5505 firewall

I figured it out.

Hello,

Hello Jon,While

Hi Jon,Sorry - I wasn't clear

Ok, so we're getting