Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,Im currently having an issues getting the image deployment process to work when using plug and play autoinstall. i believe the issues is with the image location. I tried various locations but seems to only get errors and distribution failedt...
hi there,i have a quick question about the interface range command within a CLI template. when using the command interface range gigabitEthernet 1/0/1 - 4switchport access vlan 900switchport mode accessno snmp trap link-statusno logging event link-st...
Hi there. I have a question about my cisco RV220W router. In the vlan membership section I have a few different vlans setup, I have a particular vlan for management purposes and have disabled 'Device Management' for all other vlans but for some r...
Hi there, i have a question about the proper method to setup up vlan(s) on a sg200 switch with a sv220w router. Should i setup the vlan on the router or the switch? I have small office setup, i need atleast 2 vlans to separate the networks. i want b...
I've made a little progress. it seems when deploying the template via configuration tasks the command works as it should. However, i'm trying to deploy my CLI template via PnP profile (auto install), its during this method that the configuration onl...
Okay... this is what i have so far. RV220W - port 2 = vlan1 U, Vlan2, 3, 4 Tthe SG200 is setup as the pic below. port 25 is the connection to the router. would you be able to tell me is this is setup properly?Thank youRoy
hi..thank you for the reply.. i noticed that the documention that you linked is a bit dated, as newer firmware do not support all the features listed in the admin guide. for example, the latest firmware for the RV220w no longer has the VLAN to port s...
