I am trying to navigate to and obtain a devices IP address in a macro, but I am unable to get a result using the following code: function init(){
xapi.status.get('Network IPv4 Address').then((value) => {
systemInfo.ipv4 = value;
});
}The resu...
Hi All,We have been informed of a new vulnerability on Linux / Unix systems. We have tried a command ( which is purely anecdotal at this stage ) that apparently proves whether a particular Linux or Unix system is vulnerable.This appears to show the V...
Hi All,I think this may need to be a feature request but I thought I would ask first.Is it possible to set the email template up to be reservation only, without changing this on TMS?The reason I ask is to avoid endpoints being pulled into a call that...
Hi All,Just looking to answer a basic question, can the touchpanels on the TX9000 go into standby? If so, how is it configured to do so?Thanks in advance.GK
Hi,We are working on the webex enabled telepresence and I am getting a DNS error, however our normal DNS zone works ie I can call the OSLO traffic cam's SIP uri and others outside of our business. From the VCSe I can also do an nslookup and see the A...
Hi Shawn,I have recently setup another internally and I was getting the same results. However, it appeared that the configuration at the webex end was not completely finished. It may be worth checking that out. One of the ways I figured it out was th...
Hi Ben,You can make calls using H323 without having to register the endpoint to any specific call control. The H323 mode would need to be set to 'Direct'.The best practise, in this type of deployment, for making calls externally is to setup a static ...
Hi Martin,Thanks for your reply, apologies my original port may not have been clear. Below is what we have tried:Originally followed the April Configuration Document, took some time getting our webex acc enabled for WET so when we picked it back up t...
Hi Amit/Ravi,Apologies, I am using an EX60. I had a bit of a dull moment with this when I missed one of the settings. I have done some further testing and it appears from initial upgrade it is ok. But when the unit is rebooted, the panel fails to sho...
