Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am loadbalancing Terminal Server Windows 2008 sessions with an ACE4710.I am trying to establish a Terminal Server session with Single Sign-On (SSO), but without success. Normal login with Username and Password on the TS are functionning, but ...
Hello,I have configure "RDP Load Balancing" as explained in the Software Version A3(1.0) manual.Users claim that they do not reconnect to the RDP session after a quite short inactivity time !What are the default RDP "sticky" timers and where can I se...
Why the real servers can not ping the IP address of the ACE interface ?(The real servers and ce ACE vlan interface are in the same IP subnet)Note, from the ACE we can ping the real servers and the load balancing itself is running fine
Hello,I would like to know if it is possible to have two SSL modules installed in a CSS11503 with each one having it's own "ssl-proxy-list" ("ssl-proxy-list list1" and "ssl-proxy-list list2"), but the two lists (list1 and list2) are exactly the same....
Hi, this question is looking like the one from Tan, submitted Jul 2, 2002, 11:17am PST. I have some new question and comments concerning this problem:I have configure two routers on a network with HSRP.I did a FTP from a client behind the 2 routers t...
Hi I asked Cisco a while ago the same question... the response was:"As for VPC number 201728 and higher, this is normal behavior when you configure on N5K FEX fabric ports as vPCs."RegardsFrançois
Finally I got the response frome the Cisco TAC:I understand you concerns. However, I first need to clarify which scenario are you running.There is no really much things to configure and check on the ACE regarding RDP. Advanced RDP setups usually in...
Hello,it's quite a long time since I had this RDP problem...We stopped using RDP load balancing because it involved too much HW arround the ACE (see Cisco TAC explanation at the end of the message)Now we are doing sticky on "Source IP"........There i...
Hello,Yes I have "sticky source IP" configured.Some explanation about the situation.I have 3 Windows 2008 Terminal Servers (for example: TS1, TS2 and TS3). On the ACE4710 I have a VIP address (DNS name = TSserver.mydomain.ch) which load balance the s...
Hello David,I can not answer your question now, because we only have RDP sessions load balancing.Changing the "set timeout inactivity 10800" (3h), actually has solved the problem of the RDP sessions been disconnected. But the strange thing is that th...
